Today, the task of the spraying process continues to become more complex and important in order to fulfil the process and quality demands. 

For this purpose, Wollin continues to develop its PowerSpray systematically. 

Due to the constant improving die tempering, it is also necessary to apply a release agent there where it is needed. By using a mask spray tool and the modular design of the Wollin Spraying Technology, we can set-up your spraying process precisely for these requirements. 

High productivity and process capability through:

• less use of release agents and waste water
• longer die service life
• shorter cycle times
• scrap reduction
• short set-up times